Great for simpel use
Great amp for stereo speaker or sound bar. Only part missing would be to have more gpio´s to control the DSP
Great amp for stereo speaker or sound bar. Only part missing would be to have more gpio´s to control the DSP
Nouveau client ?
Créez votre compte 0
0 Articles - 0,00 € Aucun produit
To be determined Frais de port
0,00 € Dont TVA
0,00 € Total
Les prix sont TTC
Quantité
Total
Produit ajouté avec succès à votre panier
Il y a 0 articles dans votre panier. Il y a 0 articles dans votre panier.
Total (TTC) :
Déjà vus
Avis clients
Note :
Date :
13/03/2026
Raul P.
Note :
Date :
13/03/2026
Gérard B.
Tonewinner AT-500
Correspond bien à mes attentes. Quelles sont les différences entre les modes "Pure" et "Direct"? Mais...
Correspond bien à mes attentes. Quelles sont les différences entre les modes "Pure" et "Direct"? Mais...
Note :
Date :
13/03/2026
laurent C.
mon ressenti: appareil aux finitions fragiles mais excellente sonorité
Trois Fosi v3 mono pour alimenter et soulager mon onkyo cinéma RZ 30 en face avant
(enceinte klipsch 500 rp) sonorité plutôt...
Trois Fosi v3 mono pour alimenter et soulager mon onkyo cinéma RZ 30 en face avant
(enceinte klipsch 500 rp) sonorité plutôt...
MINIDSP MCHSTREAMER Interface USB XMOS vers I2S / SPDIF / ADAT / TDM/ DSD / PDM 32bit 384kHz DSD256 - avis - Il y a 2 avis.
Seuls les utilisateurs enregistrés peuvent poster un avis. Connectez-vous ou créez un compte .
Note :
Date :
30/01/2025
Theodoros A.
Note :
Date :
15/03/2020
Ian C.
Very versatile, although not cheap
Veritable Swiss Army Knife for USB connectivity. Although this is not a cheap item, it is very useful. I use it for Toslink SPDIF to USB for my MacBook Pro which it does perfectly, but it can be configured for I2S in/out, Coax in/out, ADAT depending on the loaded firmware. Installing the firmware is easy enough.
Finding a decent Toslink to USB receiver that is better than 16 bit/44.1Khz is quite tricky. There is the Soundblaster X-Fi that can do this, but I was worried about Mac compatibility.
This works perfectly and can be powered by USB or with a 5V header on the board.
The USBStreamer would have sufficed for the rates that I record my vinyl at, but this was only marginally more expensive, and handles higher rates and DSD if I ever want to go that direction in future.
Veritable Swiss Army Knife for USB connectivity. Although this is not a cheap item, it is very useful. I use it for Toslink SPDIF to USB for my MacBook Pro which it does perfectly, but it can be configured for I2S in/out, Coax in/out, ADAT depending on the loaded firmware. Installing the firmware is easy enough.
Finding a decent Toslink to USB receiver that is better than 16 bit/44.1Khz is quite tricky. There is the Soundblaster X-Fi that can do this, but I was worried about Mac compatibility.
This works perfectly and can be powered by USB or with a 5V header on the board.
The USBStreamer would have sufficed for the rates that I record my vinyl at, but this was only marginally more expensive, and handles higher rates and DSD if I ever want to go that direction in future.
Français 
English 
