This monostable push button 250V 5A in anodised aluminium incorporates a beautiful orange LED. It is ideal for all your DIY projects and assemblies, especially as an on/off switch or as a replacement for a similar faulty button.
This monostable (single position) 250V 5A anodized Aluminium button incorporates a blue LED and a Power symbol for the most beautiful effect. It is ideal for all your DIY projects and assemblies as an on/off switch or as a replacement for a similar defective model.
This black plastic and rubber cap can be used to cover toggle switches to change their appearance. In addition, this cap has a seal at its base, allowing it to be both dust and waterproof, to protect your switch.
Here is a switch in stainless steel, 1 pole (3 contacts, 1 with closing, 1 with opening). LED 12 V. Protection class IP 67. Switching capacity 250 V AC / 5 A. Cutting diameter 19 mm. Welding pole. Light blue circle.
This NO type switch has two luminous blue switches, each with two positions. The mounting is snap-in type and is done simply with blade connectors or via a few welds. This switch can be integrated in a wide variety of DIY installations
This NO type switch has two luminous green switches, each with two positions. The mounting is snap-in type and is done simply with blade connectors or via a few welds. This switch can be integrated in a wide variety of DIY installations
This NO type switch has two luminous red switches, each with two positions. The mounting is snap-in type and is done simply with blade connectors via a few welds. This switch can be integrated in a wide variety of DIY installations.
This NO type switch has two luminous yellow switches, each with two positions. The mounting is snap-in type and is done simply with blade connectors or via a few welds. This switch can be integrated in a wide variety of DIY installations
This connector is compatible with Ø19mm push buttons and monostable/bistable switch. It allows to quickly mount a button / switch without soldering or screwing anything. This connector has 7 x 15 cm wires and is suitable for the majority of switches with RGB LED.
The ON/OFF switch by Ian Canada comes complete with mounting nut and washers. Can be connected directly to a LinearPi to make it as a master to start a whole ON/OFF control chain. A PH2.0 2Pin 15cm control cable is supplied. Can also be used to control the ON/OFF of other power supplies, but may need to cut one end of the cable and solder the...
1NO type button with blue indicator light. Operates from a monostable mechanism. The connectors dedicated to the signal / power supply can support a voltage of 220V. Those dedicated to the power supply of the indicator light (LED) can accept voltages between 5 and 24V.
1NO type switch with blue indicator light. Operates from a bistable mechanism (two positions). The connectors dedicated to the signal / power supply can support a voltage of 220V. Those dedicated to the power supply of the indicator light (LED) can accept voltages between 5 and 24V.
1NO type button with red indicator light. Operates from a monostable mechanism. The connectors dedicated to the signal / power supply can support a voltage of 220V. Those dedicated to the power supply of the indicator light (LED) can accept voltages between 5 and 24V.
1NO type switch with red indicator light. Operates from a bistable mechanism (two positions). The connectors dedicated to the signal / power supply can support a voltage of 220V. Those dedicated to the power supply of the indicator light (LED) can accept voltages between 5 and 24V.