This phase tester will allow you to perform a phase test on your speakers or on the output of a power amplifier. This type of device is mainly used to check the wiring of speakers or power amplifiers.
This Hirschmann touch point is made of nickel-plated stainless steel. It has a Ø4mm cable insertion diameter with a polypropylene (PP) insulating sleeve. Its contact resistance is 50 mOhm for a rated voltage of 60V DC.
This Hirschmann touch point is made of nickel-plated stainless steel. It has a Ø4mm cable insertion diameter with a polypropylene (PP) insulating sleeve. Its contact resistance is 50 mOhm for a rated voltage of 60V DC.
This mains noise tester allows to measure the interference and therefore the noise on a power network and to compare filtered and unfiltered systems. It operates over a frequency range of 300kHz to 700kHz. Below or above these values, an LED lights up to indicate that the value is out of range.
This socket and circuit breaker tester allows you to test your installation safely. Among other things, this product can detect a lack of earth, phase reversal, or a lack of phase or neutral. This small tester can save lives and prevent fires, and should be included in every electrician's toolbox.
This is a pair of test leads, with 4mm diameter banana plug connectors on both sides. These will be the perfect allies for your multimeter to make measurements.