This NO type switch has two luminous yellow switches, each with two positions. The mounting is snap-in type and is done simply with blade connectors or via a few welds. This switch can be integrated in a wide variety of DIY installations
This connector is compatible with Ø19mm push buttons and monostable/bistable switch. It allows to quickly mount a button / switch without soldering or screwing anything. This connector has 7 x 15 cm wires and is suitable for the majority of switches with RGB LED.
The ON/OFF switch by Ian Canada comes complete with mounting nut and washers. Can be connected directly to a LinearPi to make it as a master to start a whole ON/OFF control chain. A PH2.0 2Pin 15cm control cable is supplied. Can also be used to control the ON/OFF of other power supplies, but may need to cut one end of the cable and solder the...
1NO type switch with blue indicator light. Operates from a bistable mechanism (two positions). The connectors dedicated to the signal / power supply can support a voltage of 220V. Those dedicated to the power supply of the indicator light (LED) can accept voltages between 5 and 24V.
1NO type switch with red indicator light. Operates from a bistable mechanism (two positions). The connectors dedicated to the signal / power supply can support a voltage of 220V. Those dedicated to the power supply of the indicator light (LED) can accept voltages between 5 and 24V.
This type of switch is mainly used at the power supply input of a device to select the voltage to be applied, 110V or 220V AC, depending on the voltage delivered by your electrical network.
This 1NO1NC stainless steel bistable switch allows easy integration into your DIY projects. It has a white light circle that visually indicates the status of the button.
This 1NO type switch in PA66 operates with a bi-stable mechanism (two positions) and features a red indicator light (LED). The connectors dedicated to the signal/power supply can handle a maximum voltage of 36V and a current of 1A.